Arcan XL20 Operating Instructions Manual

Arcan XL20 Operating Instructions Manual

2 ton low lift service jack

Advertisement

Warning information
This is the safety alert symbol. It is used to alert you
to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible
injury or death.
imPortant: rEaD tHESE inStrUCtionS BEforE oPErating
BEFORE USING THIS DEVICE, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING
PROCEDURES, SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.
It is the responsibility of the owner to make sure all personnel read this manual prior to using the device. It is also the responsiblity of
the device owner to keep this manual intact and in a convenient location for all to see and read. Contact PowerStation, LLC for a replace-
ment label if your stand's label is not readable. If the operator is not fluent in English, the product and safety instructions shall be read to
and discussed with the operator in the operator's native language by the purchaser/owner or his designee, making sure that the operator
comprehends its contents.
tHE natUrE of HaZarDoUS SitUationS
WARNING
The use of Portable Automotive Lifting Devices are subject to certain hazards that cannot be prevented by mechanical means, but only
by the exercise of intelligence, care, and common sense. It is essential to have personnel involved in the use and operation of the device
who are careful, competent, trained, and qualified in the safe operation of the device and its proper use when servicing motor vehicles
and their components. Examples of hazards are dropping, tipping or slipping of loads caused primarily by improperly securing loads,
overloading, off-centered loads, use on other than hard level surfaces, and using equipment for a purpose for which it was not intended.
mEtHoDS to aVoiD HaZarDoUS SitUationS
WARNING
• Read, study, understand and follow all instructions before operating this device.
• Inspect the jack before each use. Do not use jack if damaged, altered, modified, in poor condition, leaking hydraulic fluid, or
unstable due to loose or missing components. Make corrections before using.
• Lift only on areas of the vehicle as specified by the vehicle manufacturer.
• Wear eye protection that meets ANSI Z87.1 and OSHA standards.
• Do not use jack beyond its rated capacity.
• This is a lifting device only. Immediately after lifting, support the vehicle with jack stands capable of sustaining the load before
working on the vehicle.
• Use only on a hard level surface free from obstructions so the jack is free to reposition itself during lifting and lowering operations.
• Center load on saddle. Be sure setup is stable before working on vehicle.
• Do not move or dolly the vehicle while on the jack.
• Do not use saddle adapters or saddle extenders between the stock lifting saddle and the load.
• Do not use any adapters unless approved or supplied by PowerStation, LLC.
• Always lower the jack slowly and carefully.
• This product contains chemicals known to the state of California to cause cancer and birth defects or other reproductive harm.
Wash hands thoroughly after handling.
• Failure to heed these warnings may result in fatal personal injury and/or property damage.
ConSEQUEnCES of not aVoiDing HaZarDoUS SitUationS
WARNING
Failure to read this manual completely and thoroughly, failure to understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS,
MAINTENANCE INSTRUCTIONS and comply with them, and failure to comply with the METHODS TO AVOID HAZARDOUS SITUATIONS
could cause accidents resulting in serious or fatal personal injury and/or property damage.
For Technical Questions, Call: 1-800-879-7316
WARNING
1
Model XL20
2 Ton Low Lift Service Jack
WARNING: Indicates a hazardous situation
which, if not avoided, could result in death
or serious injury.
rev. 011413

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the XL20 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Arcan XL20

  • Page 1 Model XL20 2 Ton Low Lift Service Jack For Technical Questions, Call: 1-800-879-7316 Warning information This is the safety alert symbol. It is used to alert you WARNING: Indicates a hazardous situation WARNING to potential personal injury hazards. Obey all safety...
  • Page 2 Rotate the pump handle clockwise until it stops and proceed to pump the handle until the lift arm reaches maximum height. If the condition seems better, repeat steps "A" through "C" until all air is purged from the system. XL20 User Manual rev. 011413...
  • Page 3: Operation

    3. Unit will not lift to full height. Purge air from hydraulic system as above. 4. Handle tends to raise up while the unit is under load. Pump the handle rapidly several times to push oil past ball valves in power unit. XL20 User Manual rev. 011413...
  • Page 4: Regular Maintenance

    3. Remove handle; lubricate handle receptacle and handle end. (Use white lithium spray grease only.) 4. Lubricate both rear casters bearings and both front wheels. (Use white lithium spray grease only.) Tighten all accessible hardware. XL20 User Manual rev. 011413...
  • Page 5: Parts List And Diagram

    Lift Arm Shaft Washer 18 Linkage Retaining Ring 25 Screw Bolt M5x12 Retaining ring 16 Rubber sleeve Lifting arm assembly Connecting Rod Saddle Roller Saddle screw Retaining Ring 12 Rubber Saddle Pad Upper Handle Handle Bumper XL20 User Manual rev. 011413...
  • Page 6: Specifications

    If you have any questions about warranty service, please contact PowerStation, LLC. This warranty gives you specific legal rights and you may also have other rights which vary from state to state. 1-800-879-7316 Monday - Friday 9am to 5pm EST P.O. Box 1203 Travelers Rest, South Carolina 29690 XL20 User Manual rev. 011413...

Table of Contents