Page 1
™ Dynamic Stair Trainer Model 8000 User Guide Do not Do not change the height of the stairs when someone is on the DST Manufacturer: DPE Medical Ltd. info@dpemed.com www.dpemed.com...
Do not change the height of the stairs when someone is on the DST. In case of emergency it is possible to lower the stairs with up to 3 people on the DST in order to evacuate a patient. Table of Contents: 1.
1. Introduction Dear Physiotherapist, Stair climbing is a basic everyday skill. The sooner patients can achieve independence on stairs, the sooner they can return to normal life. The revolutionary Dynamic Stair Trainer was developed in close cooperation with leading physiotherapists. It combines parallel bars and the unique feature of height adjustable stairs.
2. Precautions and safety instructions The DST is to be used under the supervision of an authorized physiotherapist. Do not place the DST next to windows that can interrupt its movement. Do not place the DST in a room with low ceiling. Make sure that when the DST is fully elevated a patient’s head dose not hit the ceiling when standing on the top stair.
3. Instructions for use General: 1. Plug in the power cord to a grounded wall outlet. 2. Verify that no objects or people will interfere with the up/down movement of the DST. 3. First, make sure that the heights of handrails suit the patient, then adjust the stairs height.
Page 6
3.1 Adjusting the width of the handrails (when applicable): 1. Lower the DST to the lowest (Horizontal) position. 2. Turn the two handles to point the rear of the DST (A) 3. Adjust the width with both hands to the next “click” position.
Page 7
3.3 Adjusting the height of the stairs: 1. Holding the control unit, press and hold the appropriate up/down button until the desired stair height is achieved. 2. A green indicator light will appear on the control unit as long as DST is connected the wall outlet. 3.
. Moving the DST in the room The DST is equipped with four retractable wheels for easy moving. In order to move the DST, carry out the following steps: 1. Lower the DST to the flat position. 2. Unplug the DST socket from the wall outlet. 3.
Page 9
olding the RSR and lifting the front moving Handle: 1. (Picture #1)-Lower the DST, lift the two handrails to the upper position and adjust outwards the rail of the WAH. 2. (Picture #2)-Unassembled manually the black knobs of the RSR. First the round knob and then the jagged knob.
5. Maintenance, Cleaning and Service The DST requires no maintenance. Before cleaning, unplug the DST from the wall outlet. The outer surfaces of the DST may be cleaned with a dry cloth. When service is required, or if you have any questions, please call your distributor.
6. Troubleshooting Should the DST fail to operate properly, please check: 1. The power cord is connected to the wall outlet. 2. The wall outlet is indeed powered; Check by connecting some other electrical appliance to the outlet. 3. The DST may be overloaded with excessive weight. Clear the DST and try again after 3 hours.
Need help?
Do you have a question about the DST 8000 and is the answer not in the manual?
Questions and answers