Table of Contents
Advertisement
6.0
Physical/electrical specifications
This section provides information relating to the physical and electrical characteristics of the drive.
6.1
AC power requirements
None.
6.2
DC power requirements
The voltage and current requirements for a single drive are shown below. Values indicated apply at the drive
connector.
Table 11:
ST3500071FC
Voltage
Regulation
Avg idle current DC
Maximum starting current
(peak DC) DC
(peak AC) AC
Delayed motor start (max) DC
Peak operating current:
Typical DC
Maximum DC
Maximum (peak) DC
[1]
Measured with average reading DC ammeter. Instantaneous +12V current peaks will exceed these val-
ues. Power supply at nominal voltage. Number of drives tested = 6, 35 Degrees C ambient.
[2]
For +12 V, a –10% tolerance is allowed during initial spindle start but must return to ±5% before reaching
7,200 RPM. The ±5% must be maintained after the drive signifies that its power-up sequence has been
completed and that the drive is able to accept selection by the host initiator.
[3]
See +12V current profile.
[4]
This condition occurs when the Motor Start option is enabled and the drive has not yet received a Start
Motor command.
NL35 Series FC Product Manual, Rev. D
ST3400071FC DC power requirements
/
1 Gbit
Notes
(Amps)
+5V
[5]
±5%
X
[1] [7]
0.94
3σ [3]
1.04
3σ [3]
1.50
3σ [1] [4]
0.57
X
[1] [6]
0.99
3σ [1]
1.01
3σ
1.68
2 Gbit
(Amps)
(Amps)
+12V [2]
+5V
±5% [2]
±5%
0.48
1.00
2.08
1.10
3.54
1.56
0.03
0.59
0.75
1.05
0.77
1.07
1.90
1.76
(Amps)
+12V [2]
±5% [2]
0.48
2.10
3.50
0.03
0.74
0.76
1.90
25
Advertisement
Table of Contents
