Reolink Go Quick Start Manual page 4

Register Online (Camera Initial Setup)
1. After the SIM card and battery are installed,
a red light will be on, and you will hear the voice
prompt"Camera is starting up, please wait". The
red LED will be solid on for some seconds and
4 English
then go solid before going out, you would
hear"Network connection succeeded", which
means the camera has been successfully
connected to the network.
Note: You may also run into the below situations:
Voice Prompt LED Status Camera Status
"SIM card Camera cannot
1 cannot be
recognize this
recognized!"
SIM card
Red LED is solid on
for some seconds
and then start to
" The SIM card is
locked with a Your SIM card
2
PIN. Please has a PIN
disable it"
3
Red LED is solid on
Camera fails to be
for some time and
registered to the
operator network
completely
"Network
connection failed"
4
Blue LED will not Camera fails to
go solid and just connect to the
Reolink server
Solution
1.Check whether you made a reverse
direction of SIM card
2.Check if the SIM card is not fully inserted,
please insert it again
Put the SIM card into your mobile phone and
disable the PIN
1.Check whether your card is activated or
not, if not please call your operator to
activate it
2.Your current location may have a weak
signal, please move the camera to a
location with better signal
Device will go into Standby mode and try to
reconnect later
English 5