Sound Settings On The Pc - Kenwood TS-990S Setting Manual

Select "Setup TX control" from the ARCP-990 "Tool" menu. The "Setup TX control"
window is displayed.
In the window above, select "ACC2/USB" in the "Modulation line" setting, and then
select "USB".
For further details refer to the ARCP-990 help. (ARCP-990 details are downloadable
from the KENWOOD website.)
●
Use the ACC2 Connector's PKS port to transmit.
This setting allows you to transmit audio received by the rear terminal by setting the
PKS port in the ACC2 Connector on the back of the TS-990S to "Low."
For details on the connector and terminal specifications, refer to the TS-990S
instruction manual.
●
Use the PF key assigned to the DATA SEND function to transmit.
By assigning the DATA SEND function to a PF key, the PF key can be used to
transmit audio received by the rear terminal
For details, refer to "4.1.6 Allocating the DATA SEND Function to the PF Keys".

4.3 Sound Settings on the PC

If you are using Windows Vista or later, by setting the sound properties of the PC, you
will be able to hear the sound of the main and sub-bands.
Connect the USB cable to the PC and the TS-990, and after turning ON the TS-990,
follow the steps below.
1) Select the Start button > Control Panel > Hardware and Sound > Sound > Recording
tab.
2) Select the microphone (USB Audio CODEC), and click the Properties.
8