Changing The Epa Filter - Fakir clyde Instructions For Use Manual

Changing micro filter cas-
sette, respectively cleaning
motor protection filter
Changing the EPA-filter
CLEANING AND MAINTENANCE
The micro filter cassette with motor protection filter is
located behind the dust bin.
1. Remove the dust bin from the appliance.
2. Remove the filter cassette from the dust bin.
3. You can clean the motor protection filter with clear water.
After cleaning 5 times you should change the motorpro-
tection filter.
4. You should change the micro filter cassette if the filter is
dirty.
5. Reinsert the dry motor protection filter into the micro filter
cassette. Insert the Cassette into the dust bin.
6. Reinsert the dust bin into the appliance. Fold the handle
down until it locks.

NOTE!
Please check the filters in the cassette after each
emptying the dust box for dirt or clogging.

NOTICE!
If the dust bag is not in place or not in the correct position
the lid closing stop will prevent the dust compartment cover
from closing correctly. Always ensure that all the filters are
inserted before you use the vacuum cleaner.
The EPA-filter is located under the exhaust air grid on the rear
of the appliance.
1. Release the exhaust air grid by pushing the slide button
upwards.
2. Remove the old EPA-filter and replace it by a new one.
3. Reinsert the exhaust air grid until it clicks into place.
EPA =

NOTE!
Change cycle, EPA-filter after approx. 6 months.
E P
FFICIENCY ARTICULATE
A
IR FILTER
en
15