Wolf CW24 Service Manual page 11

Component Removal
User Interface and Exhaust Fan Cover
To remove the user interface and exhaust fan cover, first
remove the fan assembly, exhaust fan cover, and user
interface, then (See Figure 3-4):
1. Use a T-20 to extract the six screws on the top
and bottom of the exhaust fan cover.
2. Lift the rear of the exhaust fan cover and push it for-
ward over the fan retaining screws.
3. Disconnect the six pin connector from the user inter-
face.
4. Disconnect the ground wire spade connector from
the fan assembly support.
User Interface
To remove the user interface, first remove the exhaust
fan cover, with the user interface attached, then (See
Figure 3-5):
1. Use a flat bladed screw driver to depress the two
tabs on the back of the user face at the top, while
pushing the user interface out of the exhaust fan
cover.
2. Use a flat bladed screw driver to depress the two
tabs on the back of the user face at the bottom,
while pushing the user interface out of the exhaust
fan cover.
3. Remove the user interface.
Exhaust Fan and Heater
To remove the exhaust fan and heater, first remove the
exhaust fan cover and user interface, then (See Figure
3-6):
1. Use a T-20 to extract the four screws on the bottom
of the fan cover.
2. Disconnect the red and white wire from the male
side of the power cord receptacle.
Male Power Receptacle
To remove the male power receptacle, first remove the
exhaust fan cover and user interface, then (See Figure
3-6):
1. Use a T-20 to extract the four screws on the bottom
of the fan cover.
2. Depress the tabs on the inside of the fan cover to
remove the male power receptacle.
#9001337 - Revision A - September, 2015
Cup Warming Drawer (CW24)
Cup Warming Drawer (CW24)
Figure 3-4. Screws for Exhaust Fan Cover
Tabs
3-4
Tabs
Figure 3-5. User Interface
Figure 3-6. Exhaust Fan and Heater