For The Installer: Wall Mount Kit - Scotsman MDT5N25 Service Manual

FOR THE INSTALLER: Wall Mount Kit

CAUTION
It is recommended that the wall mounting
installation be done by an experienced contractor.
The weight of the machine when in use may
exceed 350 pounds. The unit should be mounted
on a solid, rigid wall with proper fasteners for that
type of wall and of adequate strength to support
the weight of the machine when in use.
Clearance between the wall and the icemaker is a
maximum of 1 inch. Check utility connections first.
The electrical junction box will have to be removed,
and the electrical connections made inside the
cabinet in compliance with local codes. The
plumbing connections may be made through the
base, or at either side through the pre-punched
holes, using standard plumbing practices.
Interior plumbing lines must be disconnected from
the original connections and plugged when
routing through the side or base.
1. Remove machine top. Attach bracket "A" to
machine using (3) nuts, (3) flat washers, (3) lock
washers, and (3) 5/16-18 bolts received with the
kit.
16"
16"
B
12"
12"
C
MDT6N40=38.6"
MTD6N25=30"
7.83
A
2. Mount brackets "B" and "C" to the wall at the
dimensions shown for the unit. (hardware for this is
not included).
Use fasteners and wall of sufficient strength to
carry the use and weight of the
icemaker-dispenser.
3. Lift unit up and hook bracket "A" over bracket
"B". Slide unit until the two remaining holes are
aligned and secure with the remaining (2) 1/4-20
bolts, flat washers and lock washers.
May 2001
Page 5
MDT5N25 & MDT5N40
1" CLEARANCE
DO NOT LIFT ON SINK
SIDE
BASE
ROUTIN
HOLE