Advertisement
Quick Links
SARAD
GmbH
SARAD GmbH
Wiesbadener Straße 10
D-01159 Dresden
GERMANY
Local wireless network for
Radon-Scout (all versions incl. PMT)
RTM1688, RTM 1688-2
Analog Radon Sensor, Analog Progeny Sensor, Indoor Air Sensor
RTM2200, RPM2200, EQF3200, EQF3220, A2M4000
MyRIAM, DOSEman, DOSEman PRO (only versions with internal adapter)
Common
The Net Monitors network allows the wireless communication between a Computer and one
or more instruments. The range of the network reaches a few hundred meters in case of
inter-visibility. Obstacles like walls trees etc. will decrease the range significantly.
To create a network, a PC adapter (coordinator) and at least one instrument adapter
(endpoint) are required.
Coordinator
The coordinator uses an USB interface for PC connection. The power for the adapter is also
supplied by the USB. The toggle switch beside the USB connector allows the changing of the
baudrate from 9600 to 11520 bps. Which setting have to be used depends on the application
software used with the adapter:
Manual_NETmonitors_EN_31-07-12
NETmonitors
Manual
Version 7/2012
Tel.: ++49 (0)351 / 6580712
FAX: ++49 (0)351 / 6580718
e-mail:
support@sarad.de
Internet: www.sarad.de
Advertisement
Summary of Contents for SARAD Net Monitors
- Page 1 MyRIAM, DOSEman, DOSEman PRO (only versions with internal adapter) Common The Net Monitors network allows the wireless communication between a Computer and one or more instruments. The range of the network reaches a few hundred meters in case of inter-visibility. Obstacles like walls trees etc. will decrease the range significantly.
- Page 2 SARAD NETmonitors GmbH dVISION and dCONFIG: 9600 baud Radon Vision, MyRIAM: 115200 baud Endpoint Beside the antenna connector, the endpoint offers one socket to connect the data cable of the instrument (4 pins) and one more socket to connect an external power adapter (2 pins).
- Page 3 A Windows device driver for the coordinator must be installed before the unit can be used. The driver is just available if SARAD instruments with USB interface are already used with this PC. Otherwise use the CD to install the drivers correctly. Attention, the installation procedure will run two times, once for the USB and a second one for the VCP (virtual com port).