Table of Contents
Advertisement
How to Program the Remote Control,
To Search the Code Library
If none of the listed TV or VCR codes work, you can enter a code that
searches the library of codes. The remote control automatically selects the
proper code for your TV or VCR. Make sure your TV or VCR is powered-
on before you program the remote control.
1. Point the remote control away from your TV or VCR depending on which
one you are programming.
2. Do one of the following:
• To search for TV codes, press and hold
time until the LED on the remote control blinks twice,
• To search for VCR codes, press and hold
time until the LED on the remote control blinks twice.
Note: The LED on the remote control also blinks twice when it reaches
the end of its search library.
3. Using the remote control keypad enter 991. The LED on the remote
blinks twice.
4. Point the remote control toward your TV or VCR, and press
depending on which one you are programming.
• If the TV or VCR turns off, go to step 6.
• If the TV or VCR remains on, repeat step 4.
5. Press
to confirm a valid code. The remote control LED blinks twice.
6. Point the remote toward the device you programmed and power-on and
off to confirm operation.
565069 Rev B
Continued
or,
or,
EXPLORER 2000 User's Guide
and
at the same
and
at the same
or
Continued on next page
A-7
Hide quick links:
Advertisement
Table of Contents
