water saver FlushMinder G3 Quick Start

QUICK START FlushMinder G3 Automatic Dual Flush Kit
This general instruction sheet covers the basic installation procedure for this kit. Since toilet configurations vary
widely, your particular installation may require additional steps and/or hardware. For more information, please
visit our website at http://www.water-saver.org or email your questions to support
Thank You for choosing Water Saver Products ! ! !
O
VERVIEW
This electronic dual-flush toilet conversion system fits most standard Flush Handle toilets and is FULLY AUTOMATIC. Upon toilet use, a
computerized human-presence Sensor measures the "time-at-the-toilet" and then activates a Flush Motor inside the tank which lifts the
flapper valve for either a half-flush (#1) or full-flush (#2) as required. The presence detection is self-calibrating and the half and full flush
cycles are programmable with a simple Magnetic Wand and Flapper Chain (both included). The Sensor and Flush Motor installation and
setup are quick and easy with minimal tools, NO TANK REMOVAL or plumbing skills required. Both Sensor and Flush Motor are moisture
sealed and run on 6 standard AA alkaline batteries (included) for up to 1 year or 10,000 worry-free flushes. Saves water and improves
sanitation - perfect for children, the elderly, public toilets or any high-use bathroom area where flushing delinquency is a problem.
P
REPARATION
Before attempting installation, please read these Quick Start Instructions thoroughly, familiarize yourself with your specific toilet
configuration and gather any required tools. Ensure that the Sensor can be mounted just above the toilet tank with no frontal
obstructions within a range of 4 ¼ feet and that the Flush Motor will fit down inside the toilet tank roughly above the flapper valve
without interference. The battery compartment inside the Sensor requires a small Philips screwdriver to open since the cover is
tightly sealed against moisture with a silicon gasket. The Sensor unit itself can be mounted with either its attached double-sided tape
or by using the included wall fasteners or other similar fasteners as desired, so a drill and appropriate bit may be required as well.
C
OMPONENTS
DETECTION BEAM
FLUSH HANDLE
(Remains Functional)
FLUSH HANDLE
LEVER ARM
FLUSH MOTOR
BEAD CHAIN
FLUSH MOTOR
LEVER ARM
DETECTION EYE
MAGNETIC TARGET
LED INDICATORS
@water-saver.org.
SENSOR
A
FLUSH
MOTOR
(Objects not to relative scale for clarity)
MOTOR MOUNT
AA BATTERIES (6)
I
NSTALLATION (
"Home of the FlushSaver DIY Kits"
©
◊◊◊ AFM3TA1QS Rev A WSP 2017
FLUSH CYCLE
SETUP MODE
PRESENCE
DETECTION
LOW BATTERIES
CCESSORIES
BEAD CHAIN (6 inches)
MAGNETIC WAND
MOUNT COLLARS
(2 SIZES - OPTIONAL)
WALL MOUNT SET
(OPTIONAL)
)
over