Tech Lighting Mona Lisa Installation Instructions page 2

1D
8
ELECTRICAL BOX
10
8 Connect the fixture cords to the fixture arms.
Feed the fixture cords through the canopy, then place
9
the canopy against the electrical box and determine
wanted length of cord.
Once wanted length has been determined, trim the
10
cords leaving enough to make electrical connections.
1E
12
11
DRIVER
NOTE:
Before making electrical connections, use the
provided universal round crossbar if the canopy
holes do not line up with the electrical box holes.
Connect the black driver wire to the hot power line wire
11
with a wire nut.
Connect the white driver wire to the neutral power line
12
wire with a wire nut.
Connect the fixture to a suitable ground in accordance
13
to local electrical codes.
Place the driver, all wires, and wire nut connections into
14
the electrical box.
FIXTURE ARMS
FIXTURE CORD
CANOPY
9
13
14
1F
Mount the canopy to the electrical box with the two
15
long #8-32 screws.
1G
PICTURE
HANGING SLOT
PICTURE WIRE
4" CANOPY
PICTURE
Hang the picture wire in the picture hanging slot on the
16
picture light bracket.
SKIP TO SECTION 3
2
LONG #8-32
SCREW
15 15
CANOPY
16
PICTURE LIGHT
BRACKET