Advertisement
FINAL ASSEMBLY INSTRUCTIONS:
PLEASE READ MANUAL COMPLETELY BEFORE
PROCEEDING TO FINAL ASSEMBLY INSTRUC-
TIONS ON PAGE 5
PREPARING THE MACHINE FOR
OPERATION
Your floor machine will operate in a wide variety of hard
floors and carpet cleaning applications. Consult with
your local dealer or EDIC Customer Service to select the
correct accessories for the job you are going to perform.
BRUSH, PAD DRIVER
INSTALLATION
Lock the handle in the upright position and tip the ma-
chine back so it rests on the handle and wheels. Fit the
three slots of the clutch plate in the back of the brush
or pad driver over the three lugs of the drive plate (Fig.
1). Push it firmly into position and turn it counterclock-
wise until it locks in place (Fig. 2).
Fig. 1
Fig. 2
TO REMOVE PAD DRIVER: Tip the machine back so it
rests on the
handle and wheels. Turn the brush or pad driver
clockwise until it disengages and lifts off. Do not store
the machine with the brush or pad drivers installed.
PAD INSTALLATION
TO INSTALL PAD: Tilt the machine back on wheels
until machine is resting on handle. Center the pad on the
pad holder and place the pad onto the pad holder.
TO REMOVE PAD: Simply remove the pad from the
pad holder by pulling it away from the pad holder with
steady force.
MACHINE OPERATION
1. Install the pad driver and pad, brush or attachment.
2. Plug in machine.
3. Lower the handle to the desired operating position.
4. Place both hands on the handle grips with your fin-
gers around the ON/OFF lever which extends from
one side to the other underneath the handle grips.
5. The safety LOCK-OUT lever is located underneath
the right side handle grip and ON/OFF lever. To
unlock the LOCK-OUT lever, use your right hand
forefinger to press the lever down toward the back of
the switch box
6. While pressing the LOCK-OUT lever, pull the ON/
OFF lever on either side of the handle to start the
machine.
7. The LOCK-OUT lever will automatically lock when
you release the ON/OFF lever preventing the ma-
chine from being turned on until it is unlocked
again.
TO MANEUVER YOUR FLOOR MACHINE
1. Raise the handle slightly and the machine will go to
the right. The higher you raise it, the faster it will go.
2. Lower the handle and the machine will go left. The
more you lower it, the faster it will go.
3. Practice on a smooth surface to gain experience in
operating the unit before moving on to other surfac-
es.
DUAL SPEED FUNCTION FOR 17DS3-BK-P
& 20DS3-BK-P:
Use the black switch located directly behind the motor
to switch between low speed (180RPM) and high speed
(320RPM). Do not change speeds while machine is run-
ning. Always wait until motor has stopped completely
before changing speeds.
Storage:
Wipe with a clean damp cloth after every use.
Store in a clean dry place.
CORD STORAGE:
•
Unplug the cord- Clean and inspect for damage.
•
Wrap the cord around the left side handle grip.
•
Do not wrap too tightly.
4
Advertisement
