Adjusting The Steering Levers; Adjusting The Height Adjust Pedal - Scag Power Equipment Turf Tiger STT-29DFI-SS Operator's Manual

Section 4
3. Insert the lanyard pin into the cutting height index at
the desired cutting height. Push forward on the deck
lift foot lever, hold in place and pull back on the deck
release lever. See Figure 4-6. Slowly release the foot
pedal. A deck height decal is located on the cutting
height index as an aid in adjusting the deck to the
desired height. See Figure 4-5.
DECK RELEASE
LEVER
Figure 4-6. Deck Release Lever
4.14

ADJUSTING THE STEERING LEvERS

1. Position the seat to the desired location.
2. While in the operator's position without the engine
running, move both steering levers forward and
reverse to check for full function control and comfort.
3. If adjustment of the steering levers is needed, use
the following instructions to adjust.
A. Loosen the tension knob on the lever assembly.
B. Rotate the steering lever forward or backward to
achieve the optimum operating position.
C. Tighten the tension knob and repeat on the opposite
side.
D. While in the operator's position, bring the steering
levers out of the neutral lock position and check to
make sure both levers are even before operating.
4. The control handle can also be adjusted in two
different positions. If necessary, remove the two
bolts securing the control handle to the control lever.
Install the handle in the desired position.
4.15
390S0151-1
PEDAL
1. Position the seat to the desired location.
2. While in the operator's position with out the engine
running, push down on the height adjust pedal to
check for full function control.
3. The height adjust pedal can be located in three (3)
different positions for operator comfort and control.
See Figure 4-8.
HEIGHT ADJUSTMENT PEDAL LOCATIONS
19
TENSION
KNOB
Figure 4-7. Adjusting Steering Levers
ADJUSTING THE HEIGHT ADJUST
Figure 4-8. Height Adjust Pedal Locations
TENSION
KNOB
ROTATE
LEvER
390S0140-2
R