RCA HSFLC1WHA Quick Start Manual page 5

Place each twisted wirenut in the junction
box. Then align the floodlight camera base
on the junction box so that it's oriented
correctly.
Place 2 #8x1-1/2in screws through the base
and into the the mounting holes on the
junction box. Screw the base firmly in place.
Mount the floodlight camera to the
5
base and junction box.
Plug the 3-wire connector
back into the floodlight
Floodlight camera, front
Turn on power to your floodlight's
6
circuit
Confirm the floodlight camera has
7
camera base
power
as shown.
Make sure it's
completely
At first power up, the floodlights come on.
seated before
Once the floodlight camera is ready for setup,
proceeding.
the floodlights turn off and the indicator on the
front of the camera flashes blue and red.
Note: If you've installed the floodlight camera
on a switchable outlet, make sure you turn the
switch on and leave it on for the floodlight
camera to function 24/7.
Place the floodlight
camera over the base so
that the base's mounting
tabs fit into the camera's
slots. Find the 3 base
screws you removed in
step 3. Put the base screws
back into their slots and
Base screws
tighten completely.
Turn the breaker that controls
the circuit for your floodlight
back on.
5