Philips HP6570 User Manual page 13

Problem
The epilator does
not work.
4203.000.4505.1.indd 13
Cause Solution
The hairs are too Sometimes the hairs are too short to be caught. The
short. optimal length for easy removal of the hairs is 3-4mm.
The hairs that are not caught during this session will
be long enough to be removed when you epilate the
next time. You can also try to catch the hairs by
moving the appliance across the skin a few more
times.
The socket to which Make sure the socket is live. If you connect the
the appliance is epilator to a socket in a bathroom cabinet, you may
connected does not need to switch on the light in the bathroom to make
work. sure the socket is live. You could also use a working
socket outside the bathroom.
The overheat When the epilator stops working and the speed
protection has been setting indications start flashing red, the overheat
activated. protection has been activated. Let the appliance cool
down. The lights stop flashing after 30 seconds. When
the appliance has cooled down, switch on the epilator
again. If the lights start flashing again, the epilator has
not yet cooled down sufficiently.
The overload When the overload protection has been activated, the
protection is speed setting indications flash red. Turn the discs with
activated because your thumb until you can easily remove the item that
something got is blocking the rotating discs. Then switch on the
caught between the appliance again. Do not press the appliance too hard
rotating discs or onto your skin.
because you pressed
the appliance too
hard onto your skin.
EnglisH
13
01-12-09 18:34