Philips HP6570 User Manual page 11

Cleaning and maintenance
Note: Make sure the epilator is switched off and unplugged before you start to clean it.
Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone
to clean the appliance.
- Clean the appliance after each use to ensure better performance.
- Never rinse the appliance or the adapter under the tap (Fig. 15).
- Keep the appliance and the adapter dry (Fig. 16).
Cleaning the attachments
1 Remove the attachment from the epilating head (Fig. 5).
2 Remove loose hairs from the attachments with the cleaning brush (Fig. 17).
3 Rinse the attachments with lukewarm water while turning them (Fig. 18).
4 Dry the attachments before you use or store them.
Cleaning the epilating head of the epilator
1 Press the release knob (1) and remove the epilating head from the appliance (2) (Fig. 10).
2 Remove loose hairs with the cleaning brush (Fig. 19).
3 Rinse the epilating head under the tap for 5-10 seconds while turning the discs with your
thumb (Fig. 20).
Note: Never try to detach the epilating discs from the epilating head.
4 Shake the epilating head firmly (Fig. 21).
5 Dry the epilating head thoroughly with a tea towel.
Note: Make sure the epilating head is completely dry before you place it back onto the appliance.
6 To reattach the epilating head, place it on the appliance and press it onto the appliance until it
snaps home ('click') (Fig. 22).
Cleaning the shave, trim and style attachment and the trimming comb (HP6572
only)
1 Remove the trimming comb, if attached, by pulling it off the shave, trim and style
attachment (Fig. 23).
2 Press the release knob (1) and remove the shave, trim and style attachment from the
appliance (2) (Fig. 24).
3 Remove the shaving unit from the shave, trim and style attachment (Fig. 25).
4 Rinse the shaving unit, the shave, trim and style attachment and the trimming comb under a
lukewarm tap for 5 to 10 seconds while turning them a little (Fig. 26).
5 Shake the shaving unit, the shave, trim and style attachment and the trimming
comb firmly (Fig. 27).
6 Dry the shave, trim and style attachment and the trimming comb thoroughly with a tea towel
and let the shaving unit dry.
Note: Do not exert any pressure on the shaving unit to avoid damage.
7 Reattach the shaving unit to the shave, trim and style attachment. Place the shave, trim and
style attachment on the appliance and press it onto the appliance until it snaps home ('click').
4203.000.4505.1.indd 11
EnglisH
11
01-12-09 18:34