Philips HP6570 User Manual page 10

EnglisH
10
7 When you have finished shaving, switch off the appliance and clean the shave, trim and style
attachment (see chapter 'Cleaning and maintenance').
8 Put the trimming comb on the shave, trim and style attachment when you store the
appliance.
trimming with the trimming comb (HP6572 only)
Use the shave, trim and style attachment with the trimming comb attached to trim your bikini line
to a length of 3mm.
You can also use the trimming comb to pretrim long hairs (longer than 10mm) on the underarms
or bikini line.
1 Press the release button (1) and remove the epilating head from the epilator (2) (Fig. 10).
2 Put the shave, trim and style attachment on the appliance and press it until it snaps home
('click').
3 Put the trimming comb on the shave, trim and style attachment (Fig. 14).
4 Follow steps 3 to 6 in section 'Shaving the underarms and bikini line'.
Note: Make sure the surface of the trimming comb always stays fully in contact with the skin to ensure
an even trimming result.
5 When you have finished trimming, switch off the appliance and clean the shave, trim and style
attachment and the trimming comb (see chapter 'Cleaning and maintenance').
6 Leave the trimming comb on the shave, trim and style attachment when you store the
appliance.
overheat protection
The epilator has an integrated overheat protection, which prevents overheating of the appliance.
Note: To avoid overheating of the epilator, do not press the appliance too hard onto your skin. The epilator
works best when you move it over your skin without exerting any pressure.
1 If the overheat protection is activated, the appliance switches off automatically and the speed
setting indications flash red.
2 Let the appliance cool down.
The lights stop flashing after 30 seconds.
,
3 When the appliance has cooled down, you can switch it on again. If the lights start to flash
red again, the appliance has not yet cooled down completely.
overload protection
If you press the epilating head too hard onto your skin or when the rotating discs of the epilating
head get blocked (e.g. by clothes etc.), the appliance stops and the speed setting indications start to
flash red for 5 seconds.
1 Check if the rotating discs of the epilating head are blocked by turning the discs with your
thumb until you can remove whatever is blocking the rotating discs.
2 Switch on the appliance again.
Do not press the appliance too hard onto the skin.
4203.000.4505.1.indd 10 01-12-09 18:34