Leviton Innovator series Quick Reference Card

Memory Functions

Chapter 11

Saving a Show

Page 180
Procedure:
1. Press [SETUP] (Disk) [1]
2. Enter the menu item number to select type of file(s) file to save.
3. Press [ENTER]
4. Use sub bump buttons to enter a file name or select existing file by
using the up/down arrow keys
5. Press [ENTER]

Loading a Show

Page 181
Procedure:
1. Press [SETUP] (Disk) [2]
2. Use up/down arrow keys to select file to load then press [ENTER]

Soft Clear

Page 178
A Soft Clear erases the contents of some or all of the show memory.
Procedure:
1. Press [SETUP] (More) (Clear)
2. Enter [#] to select area of memory to be cleared
3. Press [ENTER]then press [1] to confirm

Hard Clear (Console Reset)

A Hard Clear will reset the board to it's default settings and erase all
console programming. Be sure to save your show files.
Procedure:
1. Hold down the [CLEAR] key.
Keep it held down until procedure is complete
2. Turn the power switch to Off
3. Wait approximately five seconds then turn the power switch to On
4. Wait for the display to fully reappear on the monitor
5. Release the [CLEAR] key
Copyright 2003 Levition Manufacturing. All Rights Reserved.
Information contained herein is subject to change without notice.
Rev:1.30.03.07
Quick Start Reference Card
Page 177
LIT-31495-00
Quick Reference Card
This card is intended as a quick reference to some basic operating
procedures for the Leviton Innovator and MC series of lighting control
consoles, please consult the User Guide for further information.
Text Conventions: Soft-keys appear inside parentheses ( ) and are
labeled S1 - S8 on the console. Hard-keys appear inside brackets [ ].
Channel Faders
Submaster Faders Playback Faders

Up and Running

If you are a new user, have little experience with lighting boards and
must quickly bring a light up on stage, follow the steps below:
Procedure:
1. Make sure the Grand Master fader is Full and Blackout key is Off.
2. Raise A/B and C/D Playback faders to top limit.
3. Bring up a channel fader or submaster fader.
4. If no lights appear, you may have to "patch" the console channel
faders to your dimming system. See next section on patching.

Patching

Chapter 9

Creating a One to One Patch

Procedure:
1. Press [PATCH] (1 TO 1) then enter [1] on keypad

Patching Conventional Channels

Follow these example steps to patch Channel 1 to Dimmer 2 at 75%:
Procedure:
1. Press [PATCH] [1] [DIMMER] [2] [AT] [75] [ENTER]
Trackball Blackout Key
Grand Master Fader
Page 138
Page 139
LIT-31495-00