Advertisement
Connecting Docks Together
You can daisy-chain multiple and/or single docks together
using the ethernet ports and ethernet cables. For the network
installation, consult your network administrator for best
practices. Designs should avoid long chains of more than five
docks or switches in series (including the upstream network
switches).
Maintenance and Environmental Issues
The ethernet dock is intended for indoor use only. Tempera-
tures should be between 0°C to 50°C. Avoid using the dock in
situations where water can enter the connector ports. It is not
sealed against water and must be kept dry, although it sheds
moisture that is on handhelds when placed into the dock.
Do not touch the docking pins (spring loaded contacts) with
conductive items when power is applied to the dock.
Do not drop items on the dock that can damage the pins.
Keep debris off of the docking pins and the connectors to
maintain the best performance.
Battery Warnings
! !
WARNING! These warnings are for the lithium ion rechargeable
batteries in the handheld:
To reduce the risk of fire or burns, do not disassemble, crush,
puncture, short external contacts, or expose to fire.
Do not disassemble or open, crush, bend or deform, puncture, or
shred.
Do not modify or remanufacture, attempt to insert foreign objects
into the battery, immerse or expose to water or other liquids,
expose to fire, explosion or other hazard.
Only use the battery for the system for which it is specified
Only use the battery with a charging system that has been
qualified with the system per this standard.
Do not short circuit a battery or allow metallic conductive
objects to contact battery terminals.
Replace the battery only with another battery that has been
qualified with the system.
Use of an unqualified battery may present a risk of fire, explosion,
leakage or other hazard.
Promptly dispose of used batteries in accordance with local
regulations.
Battery usage by children should be supervised.
Avoid dropping the battery. If the battery is dropped, especially
on a hard surface, and the user suspects damage, take it to a
service center for inspection.
Improper battery use may result in a fire, explosion or other
hazard.
Wall Charger Warnings
!
WARNING! To reduce the risk of personal injury, electrical shock,
fire or damage to the equipment:
Plug the charger into an electrical outlet that is easily accessible at
all times.
Disconnect power from the equipment by unplugging the wall
charger from the electrical outlet.
Do not place anything on the charger cord or any of the other
cables. Arrange them so that no one may accidentally step on or
trip over them.
Do not pull on a cord or cable. When unplugging the charger
from the electrical outlet, pull on the plug, not the cord.
Use only the charger supplied with the dock. Any other external
power source can damage your product and void your warranty.
Regulatory Information
United States (FCC)
This device complies with Part 15 of the FCC Rules. Operation of
this equipment is subject to the following two conditions:
1. The device may not cause harmful interference.
2. This device must accept any interference received, even if the
interference may cause undesired operation.
This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of
this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the
interference at his own expense.
!
CAUTION: Only approved accessories may be used with this
equipment. In general, all cables must be high quality and
correctly terminated. Chargers approved for this product employ
special provisions to avoid radio interference and should not be
altered or substituted.
!
CAUTION: Changes or modifications to the handheld or dock that
are not expressly approved by the manufacturer could void the
user's authority to operate the equipment.
Industry Canada
This Class A digital apparatus complies with Canadian
ICES-003. Cet appareil numérique de la classe A est conforme à la
norme NMB-003 du Canada.
This device complies with RSS-210 of Industry Canada. Operation
is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired
operation of the device.
CE Marking
Products bearing the CE marking comply with the
2004/108/EC (EMC Directive) issued by the Commission
of the European Community.
CE compliance of this device is valid only if powered with/
by a CE-marked wall charger provided by the manufacturer.
Compliance with these directives implies conformity to the
following standards:
EN 55022 Electromagnetic Interference
EN 55024 Electromagnetic Immunity
tel: 435.753.1881
1132 W. 1700 N. Logan, UT 84321
P/N 24595-00. Copyright Nov. 2014 Juniper Systems, Inc. Archer 2 Rugged
Handheld and Allegro 2 Rugged Handheld are trademarks of Juniper
Systems, Inc. Information is subject to change without notice.
l
web: www.junipersys.com
Advertisement
