AEG ABB8181VNC User Manual page 12

12 www.aeg.com
Problem
The compressor does not
start immediately after
pressing the "FROSTMAT-
IC", or after changing the
temperature.
Water flows on the floor.
Temperature cannot be set.
dEMo appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
If the advice does not lead
to the desired result, contact
the nearest Authorised
Service Centre.
7.2 Closing the door
1. Clean the door gaskets.
Possible cause
This is normal, no error has
occurred.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
The "FROSTMATIC func-
tion" is switched on.
The appliance is in demon-
stration mode.
The temperature regulator
is not set correctly.
The food products' tem-
perature is too high.
The door has been
opened often.
The "FROSTMATIC func-
tion" is switched on.
There is no cold air circula-
tion in the appliance.
2. If necessary, adjust the door. Refer to
assembly instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
Solution
The compressor starts after a
period of time.
Attach the melting water out-
let to the evaporative tray.
Switch off "FROSTMATIC
function" manually, or wait un-
til the resets automatically to
set the temperature. Refer to
"FROSTMATIC function".
Keep the OK pressed for ap-
proximately 10 seconds until a
long sound is heard and dis-
play shuts off for a short time.
Set a higher/lower tempera-
ture.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Open the door only if necessa-
ry.
Refer to "FROSTMATIC func-
tion".
Make sure that there is cold air
circulation in the appliance.