KingShield LEDFLPIR10E Installation Instructions

Part Nos: LEDFLPIR10E, LEDFLPIR18E & LEDFLPIR27E

IMPORTANT

This product should be installed by a competent person and in accordance with the
current IET Wiring Regulations. If in doubt, consult a qualified electrician.
IMPORT NT
• Never look directly into the LED light source.
• Do not use near flammable materials
• Do not use near paddling pools, fountains, ponds or similar water sources
• Do not place in water or other liquids
• Never operate with wet hands
• Never cover the fitting
• Never operate when the casing is open, or when the wiring casing is missing or
damaged, or when the protective screen is defective
• Never spray this unit and never attempt t0 clean it with a steam pressure
cleaner as this can damage the insulation seals
• Never attempt to repair this unit yourself, there are no user serviceable parts
1. Loosen the 5 cover screws.
2. Connect the wires to the connector block as shown, and re-install the five screws.
3. Secure the waterproof ring and nut tightly.
. To set the floodlight direction, loosen the screws on the sides of the mounting bracket
(underneath the housing) and adjust the floodlight angle, then re-tighten all screws
securely.
5. Mark the hole positions for the fixing bracket onto the wall. Drill and plug the wall at
Note: Leave a minimum of 2 mm above the fitting.
the marked positions,. Screw the fixing bracket to the wall with suitable screws (not
supplied).
Installation Instructions
for Lacerta Range - IP44 PIR LED Floodlights

GENERAL INFORMATION

INSTALLATION

L
10W - LEDFL10E
L
N
L - Brown
- Yellow/Green
N - Blue
18W - LEDFL18E / 27W LEDFL28E
80mm