Operation Instructions - NORPOLE NPDH50 User Manual

OPERATING INSTRUCTIONS
LOCATION
Be sure to set up the dehumidifier on a level floor, with at least 8" (20 cm) of clearance on the sides and
back and 15" (40 cm) on top. The unit is designed to be used within a temperature range of 41°F (5°C) -
95°F (35°C). It should be close enough for a properly grounded 3-prong outlet for the cord to easily reach.
CONTROLS
b
c
a. Power: Turns the dehumidifier on and off.
b. Filter: The check filter feature is a reminder to clean the Air Filter for more efficient operation. The
Filter light will illuminate after 250 hours of operation. To reset after cleaning the filter, press the Filter
button and the light will go off.
c. Cont.: Press to activate the continuous dehumidifying operation.
d. Fan
• Press the FAN button to select either HIGH or NORMAL fan speed.
• Set on HIGH for maximum humidity removal. Set to NORMAL when humidity has been
reduced or when quieter operation is preferred.
e. Timer (Timer Set Control)
• If the unit is on, pressing the Timer button once will start the Auto-Off stop program, and the
Off indicator light above the timer button will be lit. Pushing the Timer button again within 5
seconds will switch to the Auto-On start function, and the On indicator will be lit.
• If the unit is off, pushing Timer will start the Auto-On start feature, and pushing it again within 5
seconds will switch it to the Auto-Off stop feature.
• Press or hold the UP or DOWN button to set the Auto time in 0.5 hour increments, up to 10
hours, then at 1 hour increments up to 24 hours. The control will count down the time remaining
until starting or stopping.
g h
f e
8
Figure 10
d
a