Setup - Harbor Freight Tools Admiral Owner's Manual & Safety Instructions

Setup - Before use:
read the EntirE iMpOrtant SaFEty inFOrMatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tO prEVEnt SEriOuS inJury FrOM acciDEntaL OpEratiOn:
turn the power Switch of the tool off and unplug the tool from its electrical outlet
before performing any procedure in this section.
note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
assembly
1. Insert the ends of the Table Extensions into
the holes in the sides of the Base. Tighten the
Table Extension Knobs to hold the Extensions in
place. The upper edge of the Extensions will be
level with the surface of the saw. This provides
a wider base for the work material to rest on.
Mounting
Use the four bolt holes provided in the Base
to mount the Miter Saw to a stable support
before use. Mounting hardware not included.
Item 64686 For technical questions, please call 1-888-866-5797.
2. Squeeze the clip on the Dust Collection Bag to
open the mouth of the Bag. Slip the Bag over
the Dust Outlet behind the saw and release
the clip to secure the Bag to the Outlet.
®
Page 7