Table of Contents
Advertisement
Quick Links
INDUSTRIAL
f u r n i s h n e w c o m p o n e n t s f o r o l d
57 Milner Street
Newark
Nottinghamshire
NG24 4AA
T:01636 650778
www.retro tparts.co.uk
DT Series Technical Manual
INDUSTRIAL
3850 Industrial Avenue, Hemet, California 92545 Tel.: (951) 765-2250 - Fax: (951) 765-2255
Web: www.deutsch.net - Edition 2007
A STEP AHEAD
A STEP AHEAD
Advertisement
Table of Contents
Related Manuals for Deutsch DT Series
Summary of Contents for Deutsch DT Series
- Page 1 57 Milner Street Newark Nottinghamshire NG24 4AA T:01636 650778 www.retro tparts.co.uk DT Series Technical Manual INDUSTRIAL 3850 Industrial Avenue, Hemet, California 92545 Tel.: (951) 765-2250 - Fax: (951) 765-2255 Web: www.deutsch.net - Edition 2007 A STEP AHEAD A STEP AHEAD...
- Page 2 DT - 13 Amps Meets Most Signal Requirements The DTM is the connector to be used in harsh environmental in connection may be critical, the Deutsch DT Series general DTP - 25 Amps application where reliable signal circuits are critical to purpose connectors will provide the reliability and performance operating performance.
- Page 3 Thermoplastic: (All sizes) four pin configurations. CONTACT WIRE GAUGE Test Current Resistance (mV) Resistance (mV) Deutsch design of the DTM will provide reliable peak connector SIZE AWG(mm (Amps) Stamped & Formed Solids performance. GENERAL SPECIFICATIONS 20 (.50)
- Page 4 DT Series Technical Manual DT Series Technical Manual PART NUMBERING SYSTEM (DTM) DTM Series Size 20 Contacts DTM 06 - 2 S * - **** Series Prefix Special Modifications 04 = Receptacle Polarizing Position (If Applicable) 2 size 20 3 size 20...
- Page 5 DT Series Technical Manual DT Series Technical Manual CONTACTS AND APPLICATION DATA DT Series BUSSED Arrangements Solid Contacts RECOMMENDED MIN CONTACT REF CRIMP MAX RATED Standard DT Receptacles Bussed to Customer Specifications SOLID CONTACT WIRE SIZE STRIP LENGTH RETENTION TENSILE...
- Page 6 DT Series Technical Manual DT Series Technical Manual Contact Retention System (DTHD) Rquired Removal Tool (See page 12) Assembly Contact Insertion (DTM, DT, DTP) LOCKING FINGERS CONTACT CONTACT INSERTION UNLOCKED POSITION CONTACT LOCKED POSITION Contact Insertion Procedure 3. Push contact straight into 1.
- Page 7 1027-004-1200 To meet the application requirements where wires are to be protected, the DT Series may be supplied with boot adaptors. These will accept shaped boots / sleeves or shrink tubing. Parts for standard or thin wall wire are available.
Need help?
Do you have a question about the DT Series and is the answer not in the manual?
Questions and answers