WeatherTech 88TG07 Installation Instructions

Tailgate TechLiner
Thank you for purchasing your WeatherTech
affordable protection and years of reliable use if you follow these simple instructions.
Tools Needed
¼" Drive Socket Set
1
Lower the tailgate and remove all tailgate accessories
prior to installation. Clean your truck bed and tailgate with
TechCare Gentle Car
™
thoroughly before installing the Tailgate TechLiner
3
Using the supplied torx bit with a ¼" socket remove the
factory bolts from the tailgate. Place the factory bolts aside
to be re-installed in step 6.
Proudly Designed,
Engineered, and
Manufactured
in the USA.
67TG05
Installation Instructions
®
Tailgate TechLiner
®
Hardware
Parts Kit #88TG07
(1) T-15 Torx Insert Bit
(12) Plastic Washers
Also In Box
(1) Rolled Extrusion
Shampoo or soap and water. Dry
™
®
View Easy Installation Video
WeatherTech.com/install
Questions? Call customer service at 630 769 1500
Monday - Friday: 9 a.m. to 5 p.m. Central Time
. The Tailgate TechLiner
®
It is imperative to adhere the Tailgate TechLiner
the tailgate of the truck. Failure to do so may allow
the Tailgate TechLiner
result of turbulent airflow. This could cause unsafe
conditions for the operator of the vehicle or other
vehicles nearby.
2
Place Tailgate TechLiner
lay out to flatten the liner. For best results, lay liner in the
sun and put a small weight on each of the corners. Locate
.
the Velcro
Keep the Velcro
backing yet.
4
Unroll the extrusion and discard the plastic tube, be
careful not to kink the extrusion. Place the extrusion
against the edge with the opening facing the front of the
vehicle and centered on the tailgate. Slowly remove the
adhesive backing, pressing firmly as you go.
will offer incredible,
®
WARNING
to lift during travel as a
®
on a dry flat surface. Unfold and
®
pads on the bottom of the Tailgate TechLiner
®
clean and do not remove the
®
to
®
.
®