Basic Setting And Operation; Projector Operation - Sanyo POA-HDTM01 Owner's Manual

Basic Setting and Operation

Projector Operation

Turning on the Projector
1. Connect the projector's AC power cord into an AC outlet and turn on the MAIN ON/OFF
Switch. The LAMP indicator lights red and the READY indicator lights green.
2. Press the ON/STAND-BY button on the side control or on the remote control. The LAMP
indicator dims red and the cooling fans start to operate. The preparation display appears
on the screen and the countdown starts.
3. After the countdown, the input source that was selected the last time and the Lamp
mode icon appear on the screen.
If the projector is locked with a PIN code, PIN code Input Dialog Box will appear. Enter the
PIN code.
Input Selection
1. Press the INPUT 1/2/3/4 buttons on the remote control or INPUT 1/2 or 3/4 buttons on
the side control to select the HD DATA Wireless Board. (You can also select it with Menu
operation, refer to the owner's manual of the projector.)
2. Check the status of the POWER indicator on the HD DATA Wireless Board. When the HD
DATA Wireless Board is selected correctly, the POWER indicator lights green.
Receiver
POWER Indicator
INPUT MENU
Input Menu icon
Move the pointer (red arrow) to the
input which the HD DATA Wireless
Board is inserted and press the
SELECT button.
HD DATA WIRELESS TRANSMITTER BOX
OWNER'S MANUAL
1