Table of Contents
Advertisement
L5AM2/US (VCC-WB4000) GB 2003, 6, 6
PPP (Dial-up) Settings
DIAL TO PROVIDER Settings
1
Click the [PPP] menu select button.
The PPP SET screen will be displayed.
2
Select "USE" from the "DIAL TO
PROVIDER" drop-down list box and then
click the [DETAIL] button.
The PPP SET (TO PROVIDER) screen will
be displayed.
3
Set the following items for connecting to
the access point.
PROVIDER TEL. NO.:
If you need to dial "0" first, type in the
number as "0-XXX".
LOGIN ID: Type in your user ID for the
provider.
PASSWORD: Type in your password for
the provider.
4
Select the authentication settings
(AUTHENTICATION).
This sets the authentication protocol to be
used when connecting to the access point.
Set this to the protocol specified by the
Internet Service Provider. It should normally
be set to "AUTO".
Available settings:
AUTO (default setting): PAP or CHAP is
chosen automatically as required
PAP: Only PAP authentication is used.
CHAP: Only CHAP authentication is used.
5
IP address and error display
1
AUTO IP ADDRESS: The IP address is
only displayed while the camera is
connected.
2
ERROR INFO.: Shows the most recent
error information during a PPP connection.
Display details:
Modem timeout or Not connected
Line connection error
Line disconnected
PPP connection error
PPP authentication error
PPP connected and disconnected
normally
6
Click the [SET] button.
The PPP SET screen will be displayed.
7
Select the type of telephone line (CIRCUIT
TYPE).
3
This sets the type of telephone circuit that the
modem is connecting to.
Available settings:
4
TONE: For tone dialing circuits
PULSE: For pulse dialing circuits
Note: Set to "TONE" if using a terminal adapter.
8
Type in any AT commands that are
required to control the modem.
Type in "AT" at the beginning, and then type
in the commands specified by the modem
manufacturer followed by a command to
change flow control to software control.
– 56 –
English
Advertisement
Table of Contents
