Auto Mode Operation; Fan Speed - Mitsubishi Heavy Industries DXK09Z6-W User Manual

AUTO mode operation

■ Automatically selects the operation mode (COOL, HEAT, DRY) depending on the room temperature when switched on.
• If you do not want the AUTO mode program,
change to COOL, HEAT or FAN instead of
AUTO.
• Airflow direction adjustment procedure.
NOTE
• In case air is not blowing out during the
operation.

FAN SPEED

■ The FAN SPEED can be set except for DRY mode.
1
2
3
When it is a little cold
Press the
■ Each time the
–6 → –5 → ............ –1 → ±0 → +1 ............ +6.
When +6 is indicated, even if the
When it is a little hot
Press the
Page 12
■ Each time the
Page 13
+6 → +5 → ............ +1 → ±0 → –1 ............ –6.
When –6 is indicated, even if the
Setting
temp.(°C)
Page 22
1
Operation capacity by your choice
Set automatically by microcomputer
Powerful operation with high capacity
Standard operation
Energy-saving operation
• When FAN SPEED is changed from HI to LO, the sound of refrigerant
may be heard.
• When COOL mode is used if outside temperatures are low, the FAN
SPEED may change automatically to protect the air-conditioner.
EN-11
Press the MODE button.
The mode changes whenever the button is pressed.
Set to .
Press the ON/OFF button.
Press the or button.
Default preset temperature during AUTO mode is 24 °C for both cooling and
heating mode. However, it can be adjusted (Minimum 18 °C, Maximum 30 °C)
using button or button.
button.
button is pressed, the switch over occurs in the following order
button is pressed, the indicator does not change.
button.
button is pressed, the switch over occurs in the following order
button is pressed, the indicator does not change.
Remote Control display
-6 -5 -4 -3 -2
18 19 20 21 22
To stop:
Press the FAN SPEED button.
Each time the button is pressed, the fan speed changes.
AUTO HI
NOTE
+ 0
-1 +1 +2 +3 +4
23 24 25 26 27 28
Press the ON/OFF button.
MED LO
FAN SPEED
AUTO
+5 +6
29 30
HI
MED
LO