Sanyo PLV-Z700 Owner's Manual page 29

White balance (Red)
Press the Point button to lighten red tone; press the Point
7
button to deepen red tone (from -31 to +31).
White balance (Green)
Press the Point button to lighten green tone; press the Point
7
button to deepen green tone (from -31 to +31).
White balance (Blue)
Press the Point button to lighten blue tone; press the Point
7
button to deepen blue tone (from -31 to +31).
Sharpness
Press the Point button to decrease the sharpness of the image;
7
press the Point button to increase the sharpness of the image
8
(from -7 to +7).
Lamp control
This function allows you to change the brightness of the screen.
Use the Point buttons to select the desired lamp mode. You
7 8
can also select the lamp mode by pressing the LAMP CONTROL
button on the remote control.
Normal . . . . . Normal brightness.
Auto 1 . . . . . The brightness according to the input signal.
Auto 2 . . . . . Less bright and lower-sound than Auto 1.
Eco. . . . . . . . Lower brightness reduces the lamp power
consumption.
The lamp mode is automatically switched to "Eco" under no signal
input.
Gamma
Use the Point buttons to adjust the gamma value to obtain a
7 8
better balance of contrast (from -7 to +7).
Progressive
An interlaced video signal can be displayed in progressive. Use the
Point buttons to select the desired options.
7 8
Off . . . . . Disabled.
Video . . . For moving pictures.
Auto . . . . Auto adjustment according to the video signal or film
signal (3-2 and 2-2 pulldown video sources.)
Noise reduction
Noise interference on the screen can be reduced. Press the Point
7 8 buttons to change the noise reduction mode.
Off . . . . Noise reduction mode is "Off"
On . . . . Noise reduction mode is "On"
✔
Note:
• If any one of the White balance (Red, Green, or Blue) are adjusted,
the Color temp. level changes to "User. "
• Progressive cannot be selected with the computer input and when
the video signal format is 480p, 575p, 720p, or 1080p.
• Noise reduction cannot be selected with the computer input and
when the video signal format is 1080p.
8
8
8
Go on to the next page....
Image Adjustment
The selected item.
Press the Point 8 or OK
buttons to access the
selected item. The adjust-
ment bar is displayed.
Use the Point buttons
7 8
to adjust the setting
values and press the OK
button.
If you press the Point
d
button, the next item can
be selected.
Press the Point or OK
8
buttons to display the
Advanced menu.
29