Table of Contents
Advertisement
Cutting
General remarks
Preparing for
1. Establish an earth connection to the workpiece
cutting
2. Connect to the mains and turn on the mains switch for the power source
3. Set the required operating mode depending on the material of the workpiece
4. Adjust the cutting current in accordance with the material strength or the cutting
WARNING! Operating the equipment incorrectly can cause serious injury and
damage. You should not use the functions described until you have thoroughly
read and understood the following documents:
-
These operating instructions
-
All the operating instructions for the system components, especially the
safety regulations
CAUTION! Danger of injury or damage from escaping steam and hot pieces
of metal being thrown around When you press the torch trigger:
-
hold the cutting torch so that it points away from your face and body
-
do not point the cutting torch at people
Important! Never attach the earth terminal to the area of the workpiece that is to be
cut off.
Pulse mode. Recommended for cutting structural and stainless steels
Standard mode. Recommended for cutting aluminium
speed required
Important! Make sure during the cutting operation that the arc always passes
through the workpiece and that any „dross" that may form is as small as possible. If
this is not the case:
-
Reduce cutting speed or
-
increase cutting current accordingly
16
Hide quick links:
Advertisement
Table of Contents
