Controls And Connections - Fronius TransCut 300 Operating Instructions/Spare Parts List

Controls and connections

General remarks
Controls
Fig. 2 Controls
n° Function
(1) 'Standby' indicator
(2) Cutting current parameter
(3) Mode button
(4) Fill button
(5) Torch indicator
(6) Fill level indicator
WARNING! Operating the equipment incorrectly can cause serious injury and
damage. You should not use the functions described until you have thoroughly
read and understood the following documents:
- These operating instructions
- all operating instructions for the system components, especially the
"Safety rules"
(8)
(7)
(6)
(5)
(4)
- flashes on and off whilst the device is in its warm-up and reheating phase
- flashes on and off whilst the cutting torch is in its cool-down phase
- lights steady when the device is ready for use
for selecting the cutting current
for selecting the operating mode for different materials
Pulse mode. Recommended for cutting ferrometallic materials
Standard mode. Recommended for cutting aluminium
For filling the hosepack and cutting torch with the cutting medium. Must be perfor-
med every time the tank is filled and when the device has not been used for a period
of time.
- comes on when wear parts of the cutting torch are fitted incorrectly or worn
- comes on when the cutting torch's protective cap is fitted incorrectly
- comes on when most of the cutting medium has been used up. Keep a new
cartridge of cutting medium at the ready, or fill up the tank.
- flashes on and off if the tank is empty
12
(1)
(2)
(3)