After You Have Fi Nished Using Your Appliance; Working With The Continuous Shredder - Silvercrest SKM 550 B1 Operating Instructions Manual

After you have fi nished
using your appliance
1) Switch the appliance off using the rotary
switch r.
2) Set the rotary switch r to P and hold it in
GB
this position until the drive unit z comes to a
standstill (Image B).
3) Remove the lid.
4) Press down the release button e and move
the pivot arm t into operating position 4.
5) Remove the attachment you have been using
from the drive unit z.
6) Remove the mixing bowl 6.
7) Clean the appliance (see section "Cleaning
and care").
Working with
the continuous shredder
WARNING! RISK OF INJURY!
► To avoid personal injury and damage to the
appliance, never insert or place your hands
or any foreign objects into the feed tube.
► Always use the pusher and no other implement
or body part to push ingredients into the
appliance. Danger of injury due to rotating
parts!
► Switch from one accessory to another only
when the drive unit z is at a complete stand-
still! After being switched off , the drive unit z
will continue to run for a short time.
► In cases of malfunction, switch the appliance
off and remove the plug from the wall socket.
This will prevent the appliance from becoming
switched on again unintentionally.
NOTE
► The appliance may only be used when the
drive hubs not being utilised are fi tted with
their protective covers.
Make sure that neither the kneading hooks 1,
►
the whisk 2, or the beater 3 are attached
to the pivot arm t.
22
Proceed as follows to prepare the appliance for
operation using the continuous shredder 7:
1) Press down the release button e and move
the pivot arm t into operating position 4
(see the section "Operating positions").
2) Set the mixing bowl 6 into place. The base
of the mixing bowl 6 must click into the re-
cesses u on the appliance.
3) Press down the release button e and move
the pivot arm t into operating position 2.
4) Remove the protective cover from the drive
for the continuous shredder (Image C).
5) Insert the continuous shredder 7 into the
hub socket (aligning the marking " " on the
continuous shredder 7 with the marking "
on the pivoting arm t).
Turn it in an anti-clockwise direction until the
continuous shredder 7 clicks fi rmly in place
(and the marking " " on the continuous shred-
der 7 is aligned with the marking "
the pivoting arm t).
6) Set the drive shaft 0 into place.
7) Depending on the task you want to perform,
place the cutting q, shredding 9 or grating
disc 8 onto the drive shaft 0 of the continous
shredder 7.
8) Place the lid with the pusher w onto the con-
tinuous shredder 7 (so that the marking "
on the lid w is lined up with the marking " "
on the continuous shredder 7) and lock the
lid in (marking "
up with the marking " " on the continuous
shredder 7).
9) Turn the rotary switch r to the required setting.
NOTE
► Do not press too much food into the continuous
shredder 7. Take note of the table in the sec-
tion "Recommended fi lling levels".
10) Add the ingredients through the opening in the
lid with the help of the pusher.
" on
" on the lid w is lined
SKM 550 B1
"
"