Disposal of packaging
The packaging protects the device from damage during transport. The pack-
aging materials have been selected for their environmental friendliness
and ease of disposal, and are therefore recyclable.
Returning the packaging to the material cycle conserves raw materials
and reduces the amount of waste that is generated. Dispose of packaging
materials that are no longer needed in accordance with applicable local
regulations.
NOTE
►
If possible, keep the original device packaging for the entire duration
of the warranty period so that the device can be packed properly for
return shipment in the event of a warranty claim.
Inserting batteries
♦
Remove the cover
cover
♦
Undo the screw on the battery compartment cover
screwdriver to open the battery compartment
♦
Remove any discharged batteries.
♦
Insert type AA/Mignon/LR6 batteries.
♦
Note the polarity markings in the battery compartment
♦
Replace the battery compartment cover
ment
♦
Tighten the screw on the battery compartment cover
screwdriver to close the battery compartment
♦
Push the cover
The device is ready for use when the red signal LED
NOTE
►
If the red signal LED
into the battery compartment
(see section "Service").
│
GB │ CY
■
6
from the camera housing
towards the rear.
.
onto the camera housing
does not flash, try inserting fresh batteries
by pushing the
.
on the battery compart-
.
from the rear.
flashes.
or contact our Service Hotline
with a Phillips
.
with a Phillips
KAA 31 A1