Table of Contents
Advertisement
6
Gauge Assembly
STEP 1 - Place the light guide (5) on a flat surface (black side up) and
STEP 2 - Stack the diffuser (4), faceplate (3), and lens (1) in order, over
slide the buttons (6) into the slots
the buttons, and on to the light guide
STEP 3 - Reassemble the PCB and display stack with the bezel, making
STEP 4 - Reassemble and tighten screws to 2 in-lb (previously
sure screw holes are aligned through the entire assembly
assembled bezel) or 3 in-lb (new bezel). Do not over-tighten!
Advertisement
Table of Contents
