Advertisement
Quick Links
Sanyo Installation
PROJECTOR COMMUNICATIONS KIT
PLEASE READ THIS DOCUMENT FOR IMPORTANT
THIS KIT HAS BEEN SHIPPED WITH THE FOLLOWING COMPONENTS:
Kit Type: SANYO
Included Communications Adapter(s):
Quantity
1
1
THE TABLE BELOW LISTS THE POSSIBLE CONFIGURATION(S) AND CORRESPONDING
COMMUNICATIONS ADAPTER(S) FOR YOUR PROJECTOR MANUFACTURER'S VARIOUS
MODELS. PLEASE NOTE THAT YOUR SWITCHER HAS BEEN CONFIGURED AS
INDICATED BY THE " " IN THE "CONFIG AS" COLUMN. IF YOUR PROJECTOR MODEL
DIFFERS FROM THIS CONFIGURATION, YOU MUST RECONFIGURE YOUR SWITCHER
WITH THE CORRECT SETTINGS.
PLEASE REFER TO THE FOLLOWING PAGES FOR COMPLETE CONFIGURATION AND
SIGNAL CONNECTION INSTRUCTIONS.
THIS SWITCHER HAS BEEN CONFIGURED FOR:
CONFIG
MODEL
AS
PLC
PLC 8810
PLC XP10
PLC XP30
Extron • System 4 xi xi xi xi xi Switcher Series • User's Manual • P/N 68-402-02 Rev. E
SYSTEM 4xi xi xi xi xi
ATTENTION!
INSTALLATION INSTRUCTIONS
Part Number
26-467-01
26-489-01
SW1
SW2 SW3 SW4 SW5 SW6 PROJ
1
2
3
4
off on off on
off on off on
off on off on
off on off on
Configuration and Connections
Description
ADP, UNV, "A"
ADP, UNV, "J"
SANYO PLC
0
0
1
E
0
0
1
E
0
0
1
E
0
1
1
E
COMM
CABLE
ADAPTER
0
J15
26-467-01
0
J15
26-489-01
0
J15
26-489-01
0
J15
26-489-01
Page 1
Advertisement
Related Manuals for Sanyo PLC
Summary of Contents for Sanyo PLC
-
Page 1: Installation Instructions
COMMUNICATIONS ADAPTER(S) FOR YOUR PROJECTOR MANUFACTURER’S VARIOUS MODELS. PLEASE NOTE THAT YOUR SWITCHER HAS BEEN CONFIGURED AS INDICATED BY THE “ ” IN THE “CONFIG AS” COLUMN. IF YOUR PROJECTOR MODEL DIFFERS FROM THIS CONFIGURATION, YOU MUST RECONFIGURE YOUR SWITCHER WITH THE CORRECT SETTINGS. - Page 2 System 4xi ’s Main Controller Board. Begin at Step 1 to verify the correct configuration. 1. Use the Front Panel to display the Information Menu to verify that the System 4xi is already set up for the Sanyo PLC. Apply power to the System 4xi and do the following: a. Press b.
- Page 3 ____________ In a rack mount, do NOT allow the weight of the cables to be supported by the System 4 xi . See page 2-5 for cabling guidelines. Special Note: _____ Certain PLC projectors may not come equipped with a 9-pin serial port connector. In those situations, the Com adapter must be connected to Control Port 2 using the projector’s special DIN to 9-pin serial adapter, as illustrated...