NetGen Communications SmartATA Series User Manual page 48

SMART ATA
Processing Mode Description and Example
END or ROUTE End-of-number transformation. From top to bottom, number
transformation will be stopped when END or ROUTE is encountered;
Smart ATA will route the call to the default routing upon detecting END,
or route the call to the designed routing after detecting ROUTE.
Example 1:
FXS
FXS
FXS
Add suffix 8001 to the called number starting with 12345 for calls from
FXS (Phone) ports, then remove four digits in front of the number to end
number transformation yielding 58001.
Example 2:
IP[222.34.55.1]
IP[222.34.55.1]
For calls from IP address 222.34.55.1, calling party number is replaced by
2680000, and then the call is routed to FXS (Phone) port 2 with the new
calling party number.
CODEC Designate the use of a codec, such as PCMU/20/16, where PCMU denotes
G.711, /20 denotes RTP packet interval of 20 milliseconds, and /16 denotes
echo cancellation with 16 milliseconds window. PCMU/20/0 should be
used if echo cancellation is not required to activate.
Example:
IP
PCMU/20/16 codec will be applied to calls from IP with called party
number starting with 6120.
RELAY Insert prefix of called party number when calling out. The inserted prefix
number follows behind RELAY.
Example:
IP
For calls from IP with called party number starting with 010, digit stream
17909 will be outpulsed before the original called party number is sent out.
Table 19 - Routing Destination
Destination Description and Example
Calling barring. (also known as "blacklist")
ROUTE NONE
Example:
IP
Bar all calls from IP, of which the calling numbers start with 1, 3, 4, and 5.
Page 40
12345 ADD -8001
12345 REMOVE 4
12345 END
CPNX. REPLACE
CPNX. ROUTE
6120 CODEC PCMU/20/16
010 RELAY 17909
CPN[1,3-5] ROUTE
2680000
FXS 2
NONE
NetGen Communications, Inc.
Configuration Manual