NookBox Installation Guide Glass/Shock Detector Parts Identification 1. Learn/Test Button Using sharp tools such as paper clip to press the button and transmit Learn/Test code. 2. LED Indicator The LED flashes when: The Learn/Test button is pressed. • The sensor has detected shock/vibration.
Page 4
NookBox Installation Guide Glass/Shock Detector Features Battery and Low Battery Detection The Sensor use one CR2032 3V Lithium battery as its power source. Please note: ALWAYS replace battery with the correct • size and voltage. The battery is pre-inserted in the sensor. Pull out the battery insulator to activate battery.
Page 5
NookBox Installation Guide Glass/Shock Detector Supervision The Sensor will transmit a supervision signal to report its condition regularly according to the user’s setting. The factory default interval is 30-40 minutes. The user can also press the Function Button once to transmit a supervision signal manually.
Page 6
NookBox Installation Guide Glass/Shock Detector Learning and Installation Learning Pull out the battery insulator power on the sensor. 2. Refer to Control Panel manual to put panel into learning mode. 3. Presses the Learn/Test button once to transmit learn code.
Page 7
NookBox Installation Guide Glass/Shock Detector For more information visit: www.getnookbox.com...