Sinope SW2500ZB-C4 Installation Manual

Your SW2500ZB-C4 light switch
Installation
guide
SW2500ZB-C4
Smart Light Switch
zigbee 3.0
Light turned ON = Blue
Light turned OFF = Amber
The indicator intensity can be changed from
your Control4 controller.
Warnings
This product is only compatible with the Control4 home
automation system.
The installation of this light switch should be made by a
certified electrician and must be installed in conformity with
the national and local Electrical Codes.
Turn ON the light
This light switch requires a neutral wire. If your electrical box
does not have a neutral wire, you can either add one or
install the light switch at a different location.
Technical specifications
Turn OFF the light
Operating voltage 120 Vac, 60 Hz
Operation temp. 0 °C to 40 °C (32 °F to 104 °F)
Storage -20 °C to 50 °C (-4 °F to 122 °F)
Standard UL Conforms to ANSI/UL Std. 916
Standard CSA Certified to CAN/CSA Std. C22.2 No205
Maximum load:
Indicator light
450 W: LED, CFL, Halogen
600 W: Incandescent
1800 W: Resistive
1/2 HP: Ceiling fan
Zigbee 3.0 profile
Frequency: 2.4 GHz
Transmission power: +20 dBm
Receiver sensitivity: -108 dBm
Install your light switch
Make sure that the breaker for your switch is OFF
1
at the main electrical panel then remove the old
switch.
Neutral
(white)
4
Power up
the switch.
3
Use the provided screws to
secure the light switch to the
electrical box. Then, replace
the wall plate.
Neutral
(white)
2
Use the provided connectors to
connect the wires as follows:
Red Load
Black Line
White
Neutral
Blue None*
*Note: For a single pole installation, do not
remove the label on the blue wire.
For a 3-way installation, consult the 3-way
wiring diagram on the next page.
Make sure to firmly tighten the wire connectors for a
secure connection. A loose connection can be a fire
!
hazard. Special CO/ALR solderless connectors must be
used when connecting with aluminum conductors.