pyrexx RWM MC Operating Manual page 38

(2) Terminate the readout procedure
with "Schließen" (Close) by pressing
the Start button.
(3) Remove the adapter cable from the
smoke alarm device.
The readout procedure can now be per-
5
formed on other smoke alarm devices.
(4) If necessary, replace the device.
f Observe the operating manual for
the smoke alarm device.
Melder ist aus (Smoke Alarm
device switched off)
The message "Melder ist aus" (Smoke Alarm
device switched off) appears, if the smoke
alarm device is deactivated during the test:
Two signal tones
Operating Manual: RWM MC - Diagnostic device for smoke alarm devices
38
(1) Before reassembling activate the
detector again.
(2) Call up the readout protocol with "Weiter"
(Continue) by pressing the Start button.
One signal tone
The events recorded by the smoke alarm
5
device (chapter 5.5 "Events" on page 39)
and their numbers are displayed.
(3) Terminate the readout procedure
with „Schließen" (Close) by pres-
sing the Start button.
(4) Remove the adapter cable from the
smoke alarm device.
The readout procedure can now be per-
5
formed on other smoke alarm devices.
(5) If necessary: Replace the smoke
alarm device.
f Observe the operating manual for
the smoke alarm device.
5.4 Kammerwert (Chamber value)
The displayed smoke chamber value shows the
currently measured sensitivity of the readout
EN
EN