Shofu Sublite V Instructions For Use Manual

INTRODUCTION
Thank you for purchasing Sublite V. The instructions mentioned below
provide necessary information on successful operation, daily maintenance
and safe use of this unit.
Please read the instructions carefully before use to attain maximum benefits
during function and ensure durability of this unit.
Kindly keep this manual for your future reference.
Notes
• No part of this document may be copied or reproduced in any form
by any means.
• Some information in this document might become inconsistent with the
product due to product improvement.
• The information in this document is subject to change without prior notice.
• All relevant issues have been considered in the preparation of this
document. However, should you notice an omission or any questionable
item in this document, please feel free to notify SHOFU Dental.
• In case of missing pages or disorder, please contact our local dealer or
SHOFU Dental for replacement.
• SHOFU Dental will repair replace the main unit and its system in case of
trouble within the warranty period. However, we do not assume any
responsibility for subsequent damages arising from the failure of the unit.
INDICATIONS
Temporary curing of light-cured indirect composite resin, to retain the desired
shape during the fabrication of the restoration.
• The temporarily cured material has to be cured in the light-curing unit
designated for each material to ensure optimal polymerization.
• The Sublite V is not recommended for light curing Opaque material.
Sublite V
Light curing sub-unit for dental laboratory

INSTRUCTIONS FOR USE

1. Safety information

It is important to understand the following terms to use this product safely.
WARNING AND CAUTION
Important safety information is mentioned under "Warning" or "Caution".
Definitions are as follows.
Indicates a potentially hazardous situation which, if not avoided, could result
in serious injury or death.
Indicates a potentially hazardous situation which, if not avoided, may result in
minor / moderate injury or damage of property.
NOTES AND REFERENCES
Notes and references used in this manual are shown below.
Note
Indicates that potential malfunctions may occur if the description is ignored.
Reference
Supplementary information to facilitate better operation.
INSTALLATION AND CONNECTION
• Ensure earthing of terminal outlet and power socket. Electricity leak in the
• Keep away from sources of ignition to avoid fire or explosion.
• Protect from liquid or high humidity to avoid electrical leak, electric shock
• Use within the rated supply voltage to avoid fire or electric shock.
• Use one outlet supplying necessary power exclusively for this unit to avoid
• Use at room temperature (5-40 °C / 41-104 °F). Ensure that there is no
• Do not use in a dusty area. Ensure that power plug is free of dust and
• Place the unit on a flat and sturdy table that withstands the weight of the
1
Warning
Caution
This sign indicates a potentially hazardous situation which, if not
avoided, may result in burns.
Warning
main unit might cause electric shock or fire.
or fire.
Caution
overloading the circuit. If power supply is insufficient, the outlet will
overheat and might result in fire or electric shock.
condensation to avoid short circuit or electric shock.
connected securely to the outlet. Dust particles if exposed to electric
sparks may cause fire.
unit. Leave a gap of at least 20 cm (8 inches) from all sides and 30 cm
(12 inches) from the top of the machine. If adequate space is not provided
for release of heat, the machine will overheat leading to smoke or fire.