Siemens BRTRF Operating Instructions

Operating instructions

BRTRF consists of a BRTRF wireless room thermostat and a BR1 receiver. The BRTRF allows you to set the desired
room temperature (setpoint). The unit features an ergonomic setting knob for ease of temperature control.
Display
Actual room temperature in ºC
The unit is controlling to the selected
comfort temperature
Indicates when there is demand for
heat
Replace batteries
RF
Appears on the screen when the
TEST
transmitter is being tested. (1s)
Battery compartment
Two alkaline batteries type AA, 1.5 V
Commissioning before start-up
Commissioning
Remove the black transit tabs from the alkaline batteries.
Check to see if the battery holder is in the correct position.
If no batteries are inserted, fit 2 alkaline batteries type AA in the battery compartment.
BRTRF
Setting knob
Warmer/colder knob for
selecting the temperature
Changing the batteries
1.
2.
3.
Energy saving tips without sacrificing comfort
Initial power-up
Once batteries are fitted, all symbols will appear on
the display as shown for about two seconds.
Selecting the required temperature
Turn the setting knob counter clockwise to
decrease the setpoint, or clockwise to increase the
setpoint in increments of 0.5 C
The required temperature is displayed next to
the comfort temperature symbol
Get two new batteries of type AA alkaline, 1.5 volts.
Remove the battery holder, then the batteries, insert new batteries and
replace the battery holder.
The old, set temperature must be checked!
Make certain the old batteries are disposed of properly, in
compliance with environmental requirements.
Never allow room temperatures to exceed 21 C.