Handler 26A RED WING Operating Manual page 6

CHUCKS AND CHUCK CHANGERS
Handler's No. 18 Atlas Jacobs type chuck
is precision ground to provide excellent
concentricity and durability. This chuck will
accommodate burs and mandrels from 0" to
1/4" in diameter. Available for right side ONLY.
Our No. 9 Arbor band chucks are built to
accept 3/4" x 3/4" abrasive bands. These are
used for gross finishing of plastics or metals -
Right or Left.
Handler's No. 1-6 stone chucks are built to
accept abrasive stones and lathe wheels with
5/16", 3/8" and 1/4", arbor mountings for the
right and left side.
1 - 3/8" R
2 - 3/8"L
3 - 5/16" R
Note: Specify a No. 20 L or R chuck for a
polishing motor with a straight 1/2" shaft.
Handler has designed and built a full line of
automatic chucks which will adapt to your Red
Wing or other polishing motors. Handler's
automatic chucks are durable and built to
save processing time and money.
16 CHUk/CHANGER
The Handler Chuk/Changer was designed to
provide full automatic, precision changing of
1/4" and 3/32" diameter burs, mandrels and
chuck accessories with the slight movement
of a handle while the motor is turning.
The Chuk/Changer provides the technician
with exacting concentricity and quick, easy
changing of various chucks which greatly
speeds grinding, polishing and finishing
procedures. The No. 16 Chuk/Changer is
adaptable to most types of dental motors,
including older models e.g. R&M, Ritter,
Baldor, Emesco and Red Wing.
NOTE: Specify make, model and catalogue number
of lathe when ordering 16L Chuk/Changer is for use
on left side of motor.
4 - 5/16" L
5 - 1/4" R
6 - 1/4" L
No. 18 Atlas Jacobs
No. 9 Arbor band chucks
No. 1-6 stone chucks
The No. 16 is shipped complete
with chuck accessories as follows:
(1) P-16-15 Arbor Band Chuck
(1) P-16-16 Spiral Tapered Chuck
(2) P-16-19 Stone Chucks
(2) P-16-20 Mandrels - for small
abrasive wheels.
(1) P-16-8 Collet Wrench
(1) P-16-10 Clutch
(1) P-16-ADW Adapter
26A Red Wing Lathe Instruction
6