Advertisement
are being suspended. The second SB-82 should be mounted to the lower part of the
OPALine-82 enclosure, or the lower part of the lowest OPALine-82 if two OPALine-82
enclosures are arrayed (See images on page 5 of this document). The SB-82 should be
attached using the supplied hardware to the top mounting points, as shown in red color
below.
Use the mounting locations on the rear of the OPALine-82 shown in red ONLY!
Use all of the mounting hardware supplied, including all washers and lock washers. DO
NOT SUBSTITUTE ANY FASTENERS!
SB-82's are shown below mounted to both a single OPALine-82 (left image) and
mounted to two OPALine-82 enclosures with the required TBEC-82 (right image).
Once the SB-82's are securely mounted to the rear side of the OPALine-82, the
assembly may be suspended using appropriate rigging hardware. The choice of the
appropriate associated rigging hardware is NOT recommended by One Systems, or On
Point Audio, and is the responsibility of others.
4
Advertisement
