Advertisement
The image above shows an SB-82 with two OPALine-82 enclosures (a TBEC-82 is
used to join the two OPALine-82 enclosures and the SB-82 is used to suspend the
assembly). Note that two SB-82 brackets are used. One is located at the top of the
array and the second SB-82 is located at the bottom of the lower OPALine-82 enclosure
as a pull up point.
The On Point Audio SB-82 is easy to install and a flexible accessory that is designed to
allow either a single OPALine-82 or two OPALine-82 loudspeaker enclosures to be
mounted from a ceiling or other structural overhead surfaces. The only product
approved for use with the SB-82 is the OPALine-82 enclosure. NO other products may
be substituted!
NOTE: The SB-82 was designed to be mounted from a ceiling or other structural
overhead surfaces ONLY!
NOTE: The OPALine-82 enclosure and SB-82 are for INDOOR use only! DO NOT USE
IN OUTDOOR ENVIRONMENTS!
NO OTHER LOUDSPEAKERS SHOULD BE SUBSTITUTED!
The following actions MUST be performed PRIOR to beginning the installation of the
PTB-82 and OPALine-82 enclosure:
1. This installation guide must be completely read and understood.
2. The instruction manual "Rigging and Suspension of On Point Audio
2
Advertisement
