Battery Pack And Charger - Craftsman 151.98836 Operator's Manual

TO REMOVE
See Figure 2, page ii
■ Grasp blower by handle with one hand.
Insert finger tip of other hand beneath edge
of battery pack release button and press and
hold button up.
■ Slide battery toward you to remove from
terminal plate.
BLOWER TUBE AND NOZZLE
See Figure 4, page iii
■ Align slots on wide end of Blower Tube with
tabs on blower front opening. Push tube over
front opening and turn tube clockwise until
locked into place.
■ Align slots on wide end of Concentrator
Nozzle with tabs on blower tube. Push nozzle
over tube and turn nozzle clockwise until
locked into place.

BATTERY PACK AND CHARGER

BATTERY CHARGING
■ Use only with 60V Craftsman battery
chargers. The battery charger supplied is
specifically designed for the Lithium-Ion
battery used in this tool.
■ Check the power voltage! Battery chargers
operate on 120 V.
■ Charge the battery between 35.6°F and
109.4°F. This ensures an optimum battery
service life.
ASSEMBLY
WARNING!
Follow these instructions in order to avoid
injury and to reduce the risk of electric shock
or fire:
■ Replace the battery pack or the charger
immediately if the battery case or charger
cord is damaged.
■ Do not press on Trigger when inserting or
removing the battery pack.
■ Verify that the battery pack is removed
before inspecting, adjusting, or performing
maintenance on any part of the blower.
■ Read, understand, and follow the
instructions contained in the section entitled
Battery Charging.
■ Protect the battery from heat, from
continuous exposure to sun and keep away
from radiation or other heat sources. Do not
leave the battery in the tool in direct sunlight
over long periods.
■ The battery is supplied uncharged. Fully
charge the battery before using the tool for
the first time. The Lithium-Ion battery can
be charged at any time without reducing
its service life. Interrupting the charging
procedure does not affect the battery.
11 ― English