Beachcomber 500 Series Owner's Manual page 27

Hot Tub Operation Troubleshooting Guide
prOBlem sympTOm
G.F.C.I. breaker will not stay on or
trips intermittently.
jet pump is surging on high speed.
Neck jet does not shut off.
QSS Remote control is not
operating the jets and light
functions from in the hot tub.
QSS remote control is not
operating CD player functions from
in the hot tub but will operate from
out of the hot tub.
Remote control does not work, CD
Player functions pointing at CD
player.
mOsT liKely Cause
If hot tub is new; the load neutral wire has
been inserted on the neutral buss in the
panel. �oad neutral wire should be inserted
into the G.F.C.I. load neutral connection.
Heater element is defective and leaking
current to ground.
G.F.C.I. is worn out or defective. Class A,
G.F.C.I. breakers should not trip below 5
milliamps of current leakage.
Water level is too low on hot tubs that use
a jet pump for filtering.
Plug in center of Microfilter basket is not
in place on non Hush Pump™ equipped
hot tub.
RFM jet nozzles are pointed toward small
suction fitting in foot well.
Internal portion of two piece neck jet has
been unscrewed by turning too far to the
left.
Remote batteries are low.
Remote signal booster behind eye on tub
wall has a problem.
Remote is not being pointed at eye on tub
wall properly.
Emitter on popup window has come off.
Batteries need replacing. Remote control
is defective.
sOluTiOn
Call your Electrician to change location of the
load neutral wire.
Call your store for service to replace the
heater element.
Call your electrician to replace your G.F.C.I.
Raise water level in hot tub to at least ½ way
up the skimmer opening.
Install plug in basket, insert from top of
basket.
Redirect nozzles away from the small suction
fitting. Turn off all air control for RFM jets.
Carefully pry the faceplate off with a flat head
screw driver and then thread internal back
in. Then pop face plate back on and tighten
internal by turning face plate clockwise.
Replace battery.
Call store for service.
Point front of remote directly at the eye or hold
closer to eye.
Re-attach emitter to the popup window with
silicone, double-sided tape or crazy glue.
Refer to CD Player manual for location of the
remote eye.
Replace batteries or see your Beachcomber
store.