Beachcomber 500 Series Owner's Manual page 14

Table of Contents

Advertisement

Note: If tub is Hush Pump™ equipped the low speed of Massage
2 will come on automatically for 1 minute at the start of each filter
cycle to purge the plumbing lines. If the purge time is not at the
time of day you want change the filter times.
liGHT
To activate, press the
button once to turn on and again to
turn off. The light will automatically turn off after 4 hours. If your
tub has an Everlite™6 or any additional lighting features see the
instructions in this manual.
TurBO (OpTiOnal)
To activate, press the
button once to turn on and again to
turn off. The Turbo will turn off automatically after 15 minutes. The
Turbo will come on automatically for 30 seconds at the start of
each filter cycle to purge the Turbo plumbing. If the purge time is
not at the time of day you want change the filter times.
seTTinG Time ClOCK and filTer CyCles
Time set
To set the time clock to your local current time press the
button, then the
button and Set Time appears. Press the
button to advance the time or the
The time will advance quickly 5 seconds after pressing the
or
buttons. Use the same button to stop the clock at the
desired time.
filter Cycle setting
Changing filter cycles is not necessary as it comes preset from
the factory as outlined in Economy heat mode, but if you want to
change them follow instructions below.
Once time of day is set press the
Filter cycle 1. If your tub is Hush equipped changing filter cycles
does not affect the time the Hush runs. It tells the system when
to turn on the heater if you are using the Economy heat setting. If
your tub is non Hush changing the cycle time tells the two - speed
pump 1 when to operate for a filter cycle. Avoid programming a
long filter cycle that runs during the day time hours in hot summer
weather as it could cause the water to overheat. Use the
buttons to advance or backup the Filter 1 start time. Press
the same button to stop the time once you reach the desired start
time. Press the
button to advance to the Filter 1 stop time and
use the same procedure as above to adjust. Press the
to select Filter 2 start time then use the same procedure as above
to adjust, then press
to select Filter 2 stop time and once set,
press
to exit the menu.
Make sure you do not program the cycles to overlap the start or
stop time of either cycle.
Any changes to filter cycles and time are stored in the system
memory and will be retained in the event of a power outage.
1
panel lOCK
This feature might be used if you do not want anyone to operate
the tub in your absence. To lock the panel press,
then
the �CD. To unlock press
within three seconds.
TemperaTure lOCK
This feature might be used to prevent other tub users such as
children from adjusting the tub set temperature. To lock the set
temperature press,
3 seconds. To unlock press
diaGnOsTiC display messaGes
--°
OHH
OHS
SnA
Snb
to back up the time.
SnS
HFL
LF
dr
drY
ICE
button to set start time of
Refer to diagnostic and trouble shooting section on page 25 for
more detailed information.
WarninG
DO NOT ATTEMPT SERVICE OF THIS CONTRO�. CONTACT
YOUR RETAI� STORE OR SERVICE PROVIDER FOR
ASSISTANCE. FO��OW A�� OWNER'S GUIDE POWER
or
CONNECTION INSTRUCTIONS. INSTA��ATION MUST
BE PERFORMED BY A �ICENSED E�ECTRICIAN AND
A�� GROUNDING CONNECTIONS MUST BE PROPER�Y
INSTA��ED.
again
WarninG
WarninG
CONTRO� PAD. ENSURE COMFORT BY A�SO CHECKING
WATER WITH A THERMOMETER.
within three seconds. A pad lock icon will appear on
then
then
then
then
within 3 seconds.
Power to Hot Tub is off
F
Current temperature not known
Possible overheated heater: do not enter Hot Tub
Possible overheated Hot Tub: do not enter Hot Tub
Sensor problem
Sensor problem
Sensors out of balance
Possible flow through heater problem
Confirmed flow through heater problem
Possible dry heater problem
Confirmed dry heater problem
Freeze condition sensed
sHOCK HaZard!
nO user serViCeaBle parTs.
TAMPERING WITH OR MODIFYING
THIS EQUIPMENT MAY VOID YOUR
GUARANTEE.
A�WAYS TEST WATER TEMPERATURE
PRIOR TO ENTRY USING THE TOPSIDE
, then
1
then
1, then
1 then
within
then
1 then

Advertisement

Table of Contents
loading

Table of Contents