Page 2
STEP 1 Remove slat beneath the cup holder using the 3mm Hex Wrench and 8mm Box Wrench. Set slat aside. [SEE FIGURE 4.] STEP 2 FIGURE 4. Attach Basket Braces with M5 x 15mm bolts, M5 washer, and M5 Locknut using the 5mm Hex Wrench and 10mm Box Wrench.
Page 3
STEP 3 Attach Mounting Bracket with M4 x 12mm bolts, M4 washers, and M4 Locknuts. The bracket angle faced down. Do not tighten down completely. [SEE FIGURE 8.] If necessary, use included spacers and M5 x 20mm to ensure basket sits level on smaller front forks.
Page 4
Replace slat beneath the cup holder using the 3mm Hex Wrench and 8mm Box Wrench. Tighten down all slats completely. [SEE FIGURE 12.] FIGURE 12. STEP 9 Double-check all nuts and bolts to ensure they are tight. Delano Basket is installed. [SEE FIGURE 13.] FIGURE 13.
Need help?
Do you have a question about the Delano Basket and is the answer not in the manual?
Questions and answers