Table of Contents
Advertisement
E. Manually Resetting All Network Parameters to Factory Default
Step 1. Power down the K-1900-8-IP phone by disconnecting the LAN Cable (RJ45 plug).
Step 2. Take the handset offhook, then reconnect the LAN Cable (RJ45 plug).
8-12 seconds after connecting the LAN Cable you should hear 2 beeps in the handset. 6 seconds later you should hear 4 beeps, go
Step 3.
back on-hook within 6 seconds*. Unit will reset and 2 beeps will be heard in approximately 7 seconds.
Step 4. You can now enter programming by following the steps in section B above.
*Note: if you do not go back on-hook within 6 seconds, the handset will continue to beep until back on-hook. This indicates an error and network
parameters will remain unchanged.
DESCRIPTION
Connect/Disconnect
Phone Number Database
Event Log
Entry Code Database
Phone Name
Mute Current / Next Alarm
Phone Firmware
IP Firmware
Import/Export
Factory Default
Diagnostics (used to check communications, relays and proximity card reader operation)
Security code (factory set to 845464)
Access Code (1-6 digits, blank = disabled, factory set to 123456)
Inbound Call Mode (Disabled, Auto Answer, Auto Answer Secure, Ring-Low, Ring-High, Silent Monitor & Silent Monitor
Secure) (factory set to Auto Answer)
Ring Cadence (factory set to Normal Ring)
Phone Mode (Auto Dialer or Manual Dial Phone, factory Set to Auto Dialer)
Off Hook AutoDial
Off Hook Dialing Delay
Select Time Zone
Daylight Savings
Keyless/Card Logging
Relay 1 or 2 Mode (Door Strike, Outbound Call, In/Outbound Call, Doorbell, Alarm Mode,Ring, Ring Flash, factory set to Door
Strike)
Relay 1 or 2 Activation Command (1 or 2 digits, factory set to QQ and Q2) (Relay Mode must be set to Door Strike)
Relay 1 or 2 Activation Time (0.5 - 99 sec, factory set to 5 sec)
Relay 1 or 2 Int/Ext (factory set to Internal)
Relay Act. Delay (Disabled or 0.5 - 99 sec, factory set to Disabled)
Relay Latch Commands (Enabled or Disabled, factory set to Enabled)
In-Band Audio Call Progress (Enabled, Disabled, factory set to Enabled)
In-band Audio Detect Sensitivity (1-9, 1 = min, 9 = max, factory set to 5, power cycle unit after setting)
Call Length Time Out (disabled or 1 to 9 min, factory set to 3 min)
Dial Next Number on Ring No Answer (disabled, 1 - 9 = number of rings, factory set to 7)
Dial Next Number on Busy (disabled or enabled, factory set to enabled)
Live Dialing Format (Inband DTMF or RFC2833, factory set to RFC2833)
REX Input
Wiegand Direction
Programming Features Index
10
Section
Page
A
8
1
11
2
12
3
12
4
13
5
13
6
13
7
13
8
13
9
13
10
13
11
13
12
13
13
14
14
14
15
14
16
14
17
15
18
15
19
15
20
15
21
15
22
16
23
16
24
16
25
16
26
16
27
16
28
16
29
16
30
17
31
17
32
17
33
17
34
17
Advertisement
Table of Contents
